Eaton Fuller Transmission Alignment Troubleshooting
Concentrische uitlijning van de transmissie naar Engine
Common rezen doordat Misalignment
Directe overbrenging slipout
Drive gear bearing failure
Voortijdige invoeras spie slijtage door achternaaf twee lamellenkoppelingen
concentrische uitlijning
Concentric alignment means that the engine and transmission must have a common axis. The purpose of this section is to set forth the procedures to use in checking for possible misalignment.
The basic instrument needed for taking readings is a taper pointed dial indicator. The accuracy of readings is essential for correcting alignment problems. Clean all surfaces thoroughly before proceeding.
Bij het nemen van de volgende waarden, Draai de motor met de hand, do not crank the engine with starter. Remove spark plugs on gasoline engines, and release compression on diesel engines.
Notitie: Before dial indicating engine flywheel or flywheel housing, make sure engine crankshaft does not have excessive end-play. Zo ja, accurate readings cannot be obtained. Place dial indicator finger against the flywheel. Force crankshaft back and forth with pry bar. If end-play movement exceeds maximum as specified by the engine manufacturer, het zal moeten worden gecorrigeerd.
versleten Behuizingen
Inspect for worn or fretted pilot on both the transmission clutch housing and the engine flywheel housing. de 1/4″ pilot lip of transmission clutch housing can wear into the flywheel housing either by transmission loosening up or after high mileage just from the road and engine vibration.
Any appreciable amount of wear on either part will cause misalignment and the part should be replaced.
De slijtage zal in het algemeen gevonden van de 3:00 uur naar 8:00 uur positie.
Engine Vliegwielhuis Pilot
Dial indicate the pilot or bore of the engine flywheel housing. Secure dial indicator to engine flywheel with tapered point against housing pilot. Roteren vliegwiel handmatig. With chalk or soapstone, mark high and low points of indicator as it is being rotated.
The total runout will be the difference between the highest plus and minus readings. SAE maximum total runout for flywheel housing pilot is .008″ with No.1 and No.2 SAE housings.
Vliegwiel Pilot Bore
Dial geven proef lagerboring vliegwiel. With indicator secured to flywheel housing, move gauge finger to contact pilot bearing bore surface. Turn flywheel and obtain readings. SAE maximum total runout for the pilot bearing is .005″.
Transmission koppelingshuis
The transmission clutch housing face and pilot cannot be checked accurately in the field without special measuring tools. Recommended maximum runout for the transmission clutch housing face and pilot is .003″ with SAE No.1 and No.2 housings.
Ieder overbrengingsdeel je nodig hebt we het hebben! Dezelfde dag de scheepvaart beschikbaar, wereldwijd.
Vrij moeten steun van één van onze experts?