Eaton Fuller Transmission Alignment Troubleshooting
Concentric viimine Edastamine Mootori
Ühine mis kaasneksid viltuse asendi
- Otsene käik slipout
- Drive gear bearing failure
- Enneaegne võlli nuuti kulunud tagarumme kahe plaadi sidurid
Concentric viimine
Concentric alignment means that the engine and transmission must have a common axis. The purpose of this section is to set forth the procedures to use in checking for possible misalignment.
The basic instrument needed for taking readings is a taper pointed dial indicator. The accuracy of readings is essential for correcting alignment problems. Clean all surfaces thoroughly before proceeding.
Märge: Before dial indicating engine flywheel or flywheel housing, make sure engine crankshaft does not have excessive end-play. Kui seda ei, accurate readings cannot be obtained. Place dial indicator finger against the flywheel. Force crankshaft back and forth with pry bar. If end-play movement exceeds maximum as specified by the engine manufacturer, see tuleb korrigeerida.
Kantud Korpused
Inspect for worn or fretted pilot on both the transmission clutch housing and the engine flywheel housing. 1/4″ pilot lip of transmission clutch housing can wear into the flywheel housing either by transmission loosening up or after high mileage just from the road and engine vibration.
Any appreciable amount of wear on either part will cause misalignment and the part should be replaced.
Kulumine tavaliselt leida alates 3:00 asendist kella 8:00 kell seisukoht.
Mootori hooratta korpuse Pilot
Dial indicate the pilot or bore of the engine flywheel housing. Secure dial indicator to engine flywheel with tapered point against housing pilot. Pööra hooratta käsitsi. With chalk or soapstone, mark high and low points of indicator as it is being rotated.
The total runout will be the difference between the highest plus and minus readings. SAE maximum total runout for flywheel housing pilot is .008″ with No.1 and No.2 SAE housings.
Hooratas Pilot Bore
Dial näitavad piloot laager ava hooratta. With indicator secured to flywheel housing, move gauge finger to contact pilot bearing bore surface. Turn flywheel and obtain readings. SAE maximum total runout for the pilot bearing is .005″.
Käigukast Sidur Housing
The transmission clutch housing face and pilot cannot be checked accurately in the field without special measuring tools. Recommended maximum runout for the transmission clutch housing face and pilot is .003″ with SAE No.1 and No.2 housings.
Juhendeid ja muud vabad vahendid külasta meie allalaadimiste lehele
mistahes edastamise osas vajate meil see! Samal päeval laevandus saadaval, ülemaailmne.
VAJA TASUTA TOETUS ühele meie ekspertidest?