Eaton Fuller Transmission Alignment Troubleshooting
Konsentriese Belyning van oordrag aan Engine
Kwelvrae As gevolg van Uitlijnfout
- Direkte rat slipout
- Drive gear bearing failure
- Voortydige insette skag spline dra van agter middelpunt van twee plaat kloue
konsentriese belyning
Concentric alignment means that the engine and transmission must have a common axis. The purpose of this section is to set forth the procedures to use in checking for possible misalignment.
The basic instrument needed for taking readings is a taper pointed dial indicator. The accuracy of readings is essential for correcting alignment problems. Clean all surfaces thoroughly before proceeding.
nota: Before dial indicating engine flywheel or flywheel housing, make sure engine crankshaft does not have excessive end-play. As dit die geval is, accurate readings cannot be obtained. Place dial indicator finger against the flywheel. Force crankshaft back and forth with pry bar. If end-play movement exceeds maximum as specified by the engine manufacturer, dit sal moet reggestel word.
gedra Armaturen
Inspect for worn or fretted pilot on both the transmission clutch housing and the engine flywheel housing. die 1/4″ pilot lip of transmission clutch housing can wear into the flywheel housing either by transmission loosening up or after high mileage just from the road and engine vibration.
Any appreciable amount of wear on either part will cause misalignment and the part should be replaced.
Die drag sal oor die algemeen gevind word vanaf die 3:00 uur na 8:00 uur posisie.
Enjin Vliegwiel Behuising Pilot
Dial indicate the pilot or bore of the engine flywheel housing. Secure dial indicator to engine flywheel with tapered point against housing pilot. Draai vliegwiel met die hand. With chalk or soapstone, mark high and low points of indicator as it is being rotated.
The total runout will be the difference between the highest plus and minus readings. SAE maximum total runout for flywheel housing pilot is .008″ with No.1 and No.2 SAE housings.
Vliegwiel Pilot Bore
Dial dui vlieënier dra gebaar van vliegwiel. With indicator secured to flywheel housing, move gauge finger to contact pilot bearing bore surface. Turn flywheel and obtain readings. SAE maximum total runout for the pilot bearing is .005″.
Transmissie Clutch Behuising
The transmission clutch housing face and pilot cannot be checked accurately in the field without special measuring tools. Recommended maximum runout for the transmission clutch housing face and pilot is .003″ with SAE No.1 and No.2 housings.
Vir Handleidings en ander gratis hulpbronne besoek ons downloads bladsy
Enige transmissie deel wat jy nodig het ons het dit! Dieselfde dag gestuur beskikbaar, wêreldwyd.
Behoefte om vry ondersteuning van een van ons experts?