Eaton Fuller Hybrid Transmission Fault Code 131 – APG Unit 1 Configuration Error
Fault code for Eaton Hybrid Drive Systems models (MY08) EH-8E306A-U, EH-8E306A-UPG, EH-8E306A-UP, EH-8E306A-CD, EH-8E306A-T and EH-6E606B-CD. Read below to learn how to test, clear and fix fault code errors for your Freightliner, Mack, Peterbilt, Kenworth, Volvo, International, and heavy-duty truck and equipment. The Auxiliary Power Generator (APG) is a 5kW/5kVA DC/AC Inverter that is connected to the high voltage DC bus of the Eaton Hybrid electric vehicle system, and generates 60 Hz single-phase 120V AC power for utility applications. The Hybrid Controller Module (HCM) can be configured for up to two (2) APG units.
Fault Code 131 – APG Unit 1 Configuration Error Detection
The following preconditions must be met before the system detects the fault:
- HCM is powered and ignition voltage is greater than 7 volts and less than 16 volts.
Note: When troubleshooting an Inactive code refer to the Product Diagnostic Mode (PDM)
Conditions to Set Fault Code Active
- FMI 13 is set when the number of APGs responding on the link is different than the number of APGs configured in the HCM.
Fallback When Fault Code 131 is set the following conditions occur:
- Amber “Check Hybrid” light illuminates.
- Fault is stored in Hybrid Control Module (HCM) memory.
Conditions to Set Fault Code Inactive
Only Inactive faults can be cleared from the Transmission Electronic Control Unit (TECU) or HCM history using ServiceRanger. The TECU automatically clears the faults from history after 200 hours and the HCM automatically clears the faults from history after the fault has been Inactive for 200 hours.
This fault code can be caused by any of the following:
- FMI 13
- HCM configuration
Fault Code 131 – APG Unit 1 Configuration Error Test
APG 8-way low-voltage connector view