Eaton Fuller Transmission Alignment Troubleshooting

Koncentrična Uskladitev Posredovanje za podjetja

Skupna Zaskrbljenost, ki izhajajo iz neporavnanosti

  • Neposredno slipout prestava

  • Drive gear bearing failure

  • Prezgodnja vhod vijačno vreteno oblačila iz zadnje pesto dveh sklopk tablice

transmission concentric alignment

koncentričnih poravnavo

Concentric alignment means that the engine and transmission must have a common axis. The purpose of this section is to set forth the procedures to use in checking for possible misalignment.

The basic instrument needed for taking readings is a taper pointed dial indicator. The accuracy of readings is essential for correcting alignment problems. Clean all surfaces thoroughly before proceeding.

pomembna opomba:

Pri sprejemanju te odčitke, vrtenje motorja z roko, do not crank the engine with starter. Remove spark plugs on gasoline engines, and release compression on diesel engines.
Opomba: Before dial indicating engine flywheel or flywheel housing, make sure engine crankshaft does not have excessive end-play. Če se to ne, accurate readings cannot be obtained. Place dial indicator finger against the flywheel. Force crankshaft back and forth with pry bar. If end-play movement exceeds maximum as specified by the engine manufacturer, bo moral popraviti.

izrabljeni Ohišja

Inspect for worn or fretted pilot on both the transmission clutch housing and the engine flywheel housing. 1/4″ pilot lip of transmission clutch housing can wear into the flywheel housing either by transmission loosening up or after high mileage just from the road and engine vibration.

worn or fretted pilot

Any appreciable amount of wear on either part will cause misalignment and the part should be replaced.

worn transmission housing

Obraba bo na splošno ugotovljeno, od 3:00 ura za 8:00 položaj ure.

Motor Vztrajnik Ohišje Pilot

engine flywheel housing pilot
flywheel housing total runout

Dial indicate the pilot or bore of the engine flywheel housing. Secure dial indicator to engine flywheel with tapered point against housing pilot. Zasuk vztrajnika z roko. With chalk or soapstone, mark high and low points of indicator as it is being rotated.

The total runout will be the difference between the highest plus and minus readings. SAE maximum total runout for flywheel housing pilot is .008″ with No.1 and No.2 SAE housings.

Vztrajnik Pilot Bore

Dial kažejo pilotni ležaja izvrtine vztrajnika. With indicator secured to flywheel housing, move gauge finger to contact pilot bearing bore surface. Turn flywheel and obtain readings. SAE maximum total runout for the pilot bearing is .005″.

flywheel pilot bore

Sklopka Ohišje menjalnika

The transmission clutch housing face and pilot cannot be checked accurately in the field without special measuring tools. Recommended maximum runout for the transmission clutch housing face and pilot is .003″ with SAE No.1 and No.2 housings.

Za priročnike in drugih prostih sredstev obiščite našo prenosov stran

menjalnik za uporabo PDF

diagrami, Priročniki in deli datoteke PDF >>>

Kaj prenos del morate jo imamo! Isti dan ladijskega prometa na voljo, po vsem svetu.

POTREBUJETE brezplačno podporo našemu strokovnjaku?

POKLIČI ZDAJ
EMAIL ZDA