Eaton Fuller Transmission Alignment Troubleshooting

Konsantrik Aliyman nan Transmisyon Engine

Enkyetid Komen ki soti nan Aliyman

  • Dirèk Kovèti pou slipout

  • Drive gear bearing failure

  • Prematire opinyon arbr Atèl mete soti nan mwaye dèyè nan de anbreyaj plak

transmission concentric alignment

konsantrik aliyman

Concentric alignment means that the engine and transmission must have a common axis. The purpose of this section is to set forth the procedures to use in checking for possible misalignment.

The basic instrument needed for taking readings is a taper pointed dial indicator. The accuracy of readings is essential for correcting alignment problems. Clean all surfaces thoroughly before proceeding.

Remak enpòtan:

Lè w ap pran lekti sa yo, Thorne motè nan men, do not crank the engine with starter. Remove spark plugs on gasoline engines, and release compression on diesel engines.
Remak: Before dial indicating engine flywheel or flywheel housing, make sure engine crankshaft does not have excessive end-play. Si li fè sa, accurate readings cannot be obtained. Place dial indicator finger against the flywheel. Force crankshaft back and forth with pry bar. If end-play movement exceeds maximum as specified by the engine manufacturer, li pral gen yo dwe korije.

bwatye chire

Inspect for worn or fretted pilot on both the transmission clutch housing and the engine flywheel housing. 1/4 nan″ pilot lip of transmission clutch housing can wear into the flywheel housing either by transmission loosening up or after high mileage just from the road and engine vibration.

worn or fretted pilot

Any appreciable amount of wear on either part will cause misalignment and the part should be replaced.

worn transmission housing

pral mete nan jeneralman ka jwenn ki soti nan 3:00 è 8:00 è pozisyon.

Engine Volan Lojman pilòt

engine flywheel housing pilot
flywheel housing total runout

Dial indicate the pilot or bore of the engine flywheel housing. Secure dial indicator to engine flywheel with tapered point against housing pilot. Vini youn apre lòt volan nan men. With chalk or soapstone, mark high and low points of indicator as it is being rotated.

The total runout will be the difference between the highest plus and minus readings. SAE maximum total runout for flywheel housing pilot is .008″ with No.1 and No.2 SAE housings.

Volan pilòt raz

Dial endike pilòt portant te fè nan volan. With indicator secured to flywheel housing, move gauge finger to contact pilot bearing bore surface. Turn flywheel and obtain readings. SAE maximum total runout for the pilot bearing is .005″.

flywheel pilot bore

Transmisyon klòtch Lojman

The transmission clutch housing face and pilot cannot be checked accurately in the field without special measuring tools. Recommended maximum runout for the transmission clutch housing face and pilot is .003″ with SAE No.1 and No.2 housings.

Pou Manuals ak lòt resous gratis tanpri vizite paj downloads nou an

manuels transmisyon pdf

dyagram, Manuals ak Pati pdf >>>

nenpòt pati transmisyon ou bezwen nou genyen li! Menm jou anbake disponib, atravè lemond.

BEZWEN GRATIS SIPÒ NAN youn nan ekspè NOU?

RELE kOUNYE A
imèl nou